M230 waste code Queensland Amine catalyst gassed through foundry sand moulds to harden them.
- Free, no account
- Environmental Protection Regulation 2019 and Queensland guidance
- Nothing is stored
Find an Australian waste code
M230, Triethylamine foundry-sand catalyst.
Queensland
Triethylamine foundry-sand catalyst
Queensland M230: triethylamine is the catalyst used to harden sand moulds in foundries.
ComplyOnSiteIs Queensland M230 hazardous waste?
Not from the code alone. M230 is a Schedule 11 trackable-waste description. Tracking applies while the commercial or industrial waste stays regulated under section 42. Check the Schedule 9 exclusions and the section 42(4) test-out route before treating a movement as trackable. This code has no precedence mark when several descriptions fit.
For a tracked load, enter M230 as the waste code on the Queensland waste transport certificate. The generator completes Part 1, the transporter Part 2 and the receiver Part 3. Lodge it through an approved online, bulk-upload or numbered-paper route. The Queensland exclusions still apply.
What does Queensland M230 cover?
Triethylamine catalysts used to set sand in foundries. The substance and the process both matter, so the triethylamine must have been used to set foundry sand.
- Official wording
- triethylamine catalysts for setting foundry sands
- Rule or list
- Environmental Protection Regulation 2019
Is foundry-sand catalyst waste Queensland M230?
| Code | When it fits |
|---|---|
| M230 | Triethylamine was the catalyst used to set foundry sand. |
An asterisk in Queensland's tracking list marks which description wins when several fit. It is not an EWC hazardous-waste marker. A resource leaves the waste regime only when it meets its end-of-waste code or approval conditions.
Which wastes take Queensland M230?
| Waste | When it’s M230 |
|---|---|
| Foundry catalysts | The material is an amine or another nitrogen compound this entry takes. |