F011 RCRA waste code Used cyanide solution from cleaning heat-treating pots.
- Free, no account
- Based on 40 CFR 261.31 and EPA hazardous-waste rules
- Nothing is stored
Find a federal hazardous waste code
F011, Spent cyanide solution from cleaning heat-treatment salt pots.
F-listed waste
Spent cyanide solution from cleaning heat-treatment salt pots
F-list process waste.
Is F011 hazardous waste?
Yes. F011 is a nonacute F-listed hazardous waste when the named source process and waste stream match. The federal table gives it hazard code R, T for reactivity and toxicity.
F011 is listed by source, so how and where the waste arose decides it, not a concentration test alone. A test can add a characteristic code but doesn't remove the listing once its conditions are met. On a required hazardous waste manifest, put F011 in Item 13. Look up the VSQG exemptions and empty-container rules too.
What does F011 cover?
Spent cyanide solutions from cleaning salt bath pots in metal heat treating. The waste form and its source process must both match the F-list wording.
- Hazard code
- R, T for reactivity and toxicity
- Rule
- 40 CFR 261.31
Is spent cyanide pot-cleaning solution F011, F010 or F012?
| Code | When it fits |
|---|---|
| F011 | Spent cyanide solutions from salt bath pot cleaning from metal heat treating operations. |
| F010 | Quenching bath residues from oil baths from metal heat treating operations from a process that uses cyanide. |
| F012 | Quenching waste water treatment sludges from metal heat treating operations from a process that uses cyanide. |
The operation and waste form pick the listing, not the chemical content alone. The rows show nearby listed streams, not every code that could apply. Add any characteristic or other listing that also fits, since one waste can carry more than 1 federal code.
Which wastes take F011?
| Waste | When it’s F011 |
|---|---|
| Cyanide heat-treatment waste | Spent cyanide solution from salt-bath pot cleaning in metal heat treating |
Which codes sit beside F011?
| Code | What it is |
|---|---|
| F006 | Wastewater sludge from electroplating |
| F007 | Spent cyanide plating-bath solution |
| F008 | Bottom residue from cyanide plating baths |
| F009 | Spent cyanide baths used to strip or clean plated metal |
| F019 | Wastewater sludge from aluminum conversion coating |
| F020 | Waste from making or manufacturing use of tri- or tetrachlorophenol |
| F021 | Waste from making or manufacturing use of pentachlorophenol |
| F022 | Waste from using chlorobenzenes under alkaline conditions |
Sources
- 40 CFR 261.31 — Hazardous wastes from non-specific sources
- 40 CFR 261.3 — Definition of hazardous waste
- 40 CFR 261.4 — Exclusions
- 40 CFR 260.10 — Definitions
- 40 CFR 262.14 — Conditions for exemption for a very small quantity generator
- 40 CFR 262.20 — General requirements
- Hazardous Waste Manifest Instructions
- 40 CFR 261.7 — Residues of hazardous waste in empty containers
ComplyOnSite